1.) Tripod stand: Finished in baked hammertone paint. Leveling screws and plated, metallic rod. Two base legs have a hole each to take clips at no 4. Third leg has a through hole for a screw at no. 10.
2.) Slide: 2 half-meter scales, rigidity clamped at ends by L-section, with metal extensions for holding pulleys at no. 12.
3.) Lever: half-meter wood scale with holes drilled every 2.5cm.
4.) Clips: 2 springs-steel clips with 2.5cm stems to fit holes in tripod legs.
5.) Clamps: 2 pieces, rectangular, metal block with two through holes and two tightening screws. Can take adapter at no. 6, slide holder at no. 8 and pivot at no. 9.
6.) Adapter: A 2.5cm metal cube with through holes for use with clamps at no. 5 and slide holder at no. 8. Tightening screw. Stem diameter 12.5mm, length 2.5cm.
7.) Right angled support painted, right angled metal bracket with collar and tightening screw. Pulley at no. 11 can be hung through its hole
8.) Slide holder: Metal block raised at center to take slide. With washer and a tightening screw. Stem diameter 12.5mm, length 2.5cm.
9.) Pivot: Length 2.5cm, diameter 12.5mm, with spindle diameter 3mm and milled head nut. For use with lever at no. 3.
10.) Screw: Milled head, 37mm screw, with washer and wing nut. Use with slide at no. 2. Slide can also be held vertically to base with the help of this screw.
11.) Pulley: 7cm metal pulley in open, metal frame with 2 hooks.
12.) Pulleys: 2 piece, as above, diameter 5cm.
13.) Roller with bracket: 500g, diameter 3.7cm, with 2 pivoted yokes and 2 hooks.
14.) Disc: 5cm, accurately centered with axle pin.
15.) Pendulum Bob: Wooden Bob with hook and pointer.
16.) Pendulum Bob: As above, metal.
17.) Cord: 3m, with two rings.
|
SINGHLA SCIENTIFIC INDUSTRIES
All Rights Reserved.(Terms of Use) Developed and Managed by Infocom Network Private Limited. |